be able to measure the Z axis to finish homing, in other words, after checking the x y axis, the Z axis goes up a little, bltouch test rod lowers, Z axis goes down until it touches the table, bl touch detects the contact, Z axis goes up a little, Z axis goes down a little, BL touch detects the touch again, and ends homing 3.1.3. Printer I got myself the Ender 3. The Home position is about 1 mm left and 2 mm in front of the front left corner. Now, the hotend center axis is 11 mm from the carrier plate with the "Mk 10" cooler mounted right onto a pair of 5 mm pegs that are part of the plate. As I want to change to an e3D v6, which has a diameter of 22 mm, I will have to move out Creality Ender 3 X axis homing issue Ask Question Asked 3 years, 8 months ago Modified 3 years, 8 months ago Viewed 16k times 1 I bought an Ender 3 recently. Auto-home is on the right front moving away from the end stop. I did reverse the wiring of the X axis motor, it did not work. I had Marlin 2.x uploaded, it didn't work too. Marlin 2.x: Z axis not homing Ender 3 V2 with new 3DTouch Solved Hello I just installed a Triangle labs 3D touch on my ender 3 v2. I wired it to the BLTouch port on the board. I flashed a UBL 10x10 BLTouch version of Jyers Marlin specifically this version (E3V2-UBL-BLTouch-10x10-v4.2.2-v2..1.bin). The z axis homing is acting inconsistent no matter what I use to command it - the LCD on the printer itself - the Repetier Host software I don´t have bed autoleveling of any kind. I already surfed through tons of forums and I could not find a fix for my issue. The reasons that Ender 3 Z-Axis is not moving could be printing scale issues, motherboard failure, or eccentric nuts problem. To fix the eccentric nut issue, loosen them and do tightening them. For avoiding the printing scale issue, loosen the screws on the lead screw bracket. iDVS.

ender 3 z axis not homing